Submersible pumps being an integral part of both urban and rural lives are prone to regular wear and tear. The components fitted within the pumps seldom generate glitches that can be easily fixed once known. Troubleshooting common submersible pump problems is discussed in this article. Also, we are going to tell you how orbit pumps are superior in performance than ordinary jet pumps available in the market.
Jet pump not working after Sudden voltage spike
Has your submersible pump suddenly stopped working? Check out the Motor and installation to solve the problem of the submersible pump not working.
Improper maintenance
Improper handling of the jet pump can leave it damaged and tampered unknowingly. If you do not handle the installation part correctly or repeatedly switch on the pump in case of voltage fluctuations, things may not remain favourable for you.
Submersible pump not functioning due to sudden temperature change
If the submersible pump is not functioning, there can be several reasons including overheating, low-voltage power, foreign material deposition and sudden temperature change. Orbit pumps can automatically detect the temperature fluctuations and handle the vulnerability naturally. The special components within these pumps help them to last for years without creating glitches.
Submersible pump motor not working
-Check out the fuse or the circuit breaker in case the motor of the pump is not working. The tripping may be caused because of the fuse which needs to be either replaced or fixed.
-presence of debris in the contact point of the pump switch can lead to breakdown of the motor. Clear away the corrosion and debris to solve the issue.
-Sand buildup over the surface of the pump may make it difficult for it to work. Simply clear away the build up and the motor shall start working again immediately.
Excessive noise in submersible pump
Take a note of the valves and ensure that the water flow is proper. Most of the time, submersible pumps create noise because of excessive cavitation. Orbit pumps are efficiently designed to avoid such scenarios. Orbit solar pumps avoid cavitation and naturally adjust according to the surroundings.
Submersible pump failure after clogging
The submersible pump can simply stop working after debris and sand gets inside the impeller. Such a situation can make the best motor pump to work hard and create a rattling sound. Remove the components that are blocking the surface manually. Choose anti-ragging and retrofitting impellers for better efficiency from orbit .
Jet pump not working after water seepage
The motor or other components of the jet pump might corrode with time while allowing water seepage within. This can can short circuiting or bearing failure. The best would be to replace the mechanical seal and assure motor insulation to avoid future damages.
Submersible pump not switching on
Sometimes, installation errors and common miss positioning mistakes can result in the submersible pump to run dry. This physical misalignment can cause more vibration and discrepancies. Checking out the jam to float switches and fixing them remains a major task ahead in such a scenario. One can also go for proper mounting systems to prevent misalignment and backflow.
